L-RAY/2000

The L-RAY/2000 is the systematic further development of the L-RAY/1000. The aim was to considerably increase the power capability in all areas of the system and thus improve the practical operation. This has been achieved by using high-power class D amplifiers and larger speakers with a considerably higher power capability and a higher efficiency. The high-performance magnetostatic tweeters operate on preceding waveguides which result in a good acoustic coupling of the individual systems. A 6.5" special system which has especially been developed for radiating the important midrange is supported in the lower midrange by two further 6.5" bass-midrange speakers. Two 12" systems of long excursion radiate the bass range and provide a solid and powerful deep fundamental bass reproduction, even without subwoofer support. The DSP system with the respective software is identical to the one included in the L-RAY/1000 and impresses by an easy and intuitive operation. The system is supplied with the same robust mounting frame which is suitable for suspended installation or ground-stacked configuration. The array elements can be curved in steps of 1°. The individual components can be locked with quick-release pins. The mounting frame also allows for suspended installation of the array elements only, without the subwoofer. Professional PA speaker array (controlled by DSP software), active, 3,400 WMAX, 2,000 WRMS (1,000 W+1,000 W)   Array of high power capability with 4 mid-high range speaker units and a dual bass module A cluster with up to 4 complete systems is possible Mounting frame for suspended installation or ground-stacked configuration The array elements can be curved in steps of 1° Quick and easy installation with quick-release pins DSP-controlled 2-way active module with digital amplifiers The software allows the following adjustments (min. system requirement is a Windows PC only, WIN98 or higher, with CD drive and interface): Parametric equalizer (6 bands) Filters (high-pass or low-pass up to 36 dB/oct. with various characteristics) Gain, level at the inputs and outputs Compressor and limiter Delay     Up to 10 L-RAY systems can be addressed via one RS-485 data bus. With the optional USB/RS-485 converter DA-70157, a PC or notebook with USB interface can be connected to the serial RS-485 interface The factory presets are stored in the system and can be restored at any time System connection cable (NEUTRIK SPEAKON) Mains connection via PowerCon® jack (e.g. with mains cable AAC-115P) The robust wooden cabinets of birch plywood feature grilles and a robust strucutured coating   The L-RAY/2000 is a very high-quality solution for every PA application where both a perfect tonality and a perfect radiation across the room are required. The advantages of the system particularly take effect with fixed installations in clubs and discotheques as well as mobile stage applications. For larger PA applications, the use of several L-RAY systems in a cluster is recommended. For installation by experts only! Please pay attention to the use of appropriate installation material, as otherwise persons and units will be put at risk. The unit is equipped with a PowerCon® jack. Supplied without mains cable (AAC-115P is available at option).  

Active/passive: active
Operating voltage: -
Impedance: -
Amplifier power: 2,000 W (1,000 W + 1,000 W)
Max. power: 3,400 W
THD: < 0.1 %
S/N ratio: -
Frequency range: 40-20,000 Hz
Input signal: 1-10 V/30 kΩ
System: speaker array
Bass speaker: 2 x 30 cm (12", bass speaker)<br/>8 x 17 cm (6.5", bass-midrange speaker)
Midrange speaker: 4 x 17 cm (6.5")
Tweeter: 4 x magnetostatic speaker+ waveguide
Number of speakers: 18
Radiation angle/Beam angle: hor. 120°, vert. 30°-90° var.
Music power: -
Power rating: -
Sensitivity: 98 dB (MHT)<br />94 dB (sub)
Max. rated SPL: 125 dB
Mounting facility: -
Admiss. ambient temp.: 0-40 °C
Power supply: ˜ 230 V/50 Hz/3,500 VA
Dimensions: 730x516x630 mm (subwoofer)<br />730x740x420 mm (4 x MHT system)
Width: -
Height: -
Depth: -
Weight: 136 kg
Inputs: XLR jack (line),<br/>NEUTRIK SPEAKON (speaker)<br/>PowerCon (power supply)
Outputs: XLR par. out (line),<br/>NEUTRIK SPEAKON par. out (speaker)
Other features: interface for DSP programming:<br/>USB, RS-232, RS-485 IN & OUT,<br/>supplied with software which is both<br/>extremely easy to use and very efficient